Sunshade 3×3

Trevi

Sunshade 3x3 / cod.995+929/B8+999

The Piazza Trevi sunshade by EMU D&S Lab can be used in both contract and residential settings to provide welcome shade and privacy. Its innovative, remote-controlled adjustable lighting system, as well as the distinctive spoke design featuring LED lights incorporated into the slats makes it an indispensable accessory for outdoor areas, even at night. The sunshade allows practical opening and closure without needing to move the furniture and table dressings underneath. A range of accessories including gutters and bases for floor or wall mounting round out its functionality.
 

Collection:  Trevi

More Info
CLICK PCON – HIDDEN
Where to Find it

Technical Info

Weight: 87.5 Kg
Dimensions L/P/H: 303 x 323 x 307 cm
Pole: 9x13.5 cm
Cover: Yes
Cover Type: FC/981
Light kit: 4 LED profiles with a length of 53cm with opal screen and total luminous flux of 2520lm. Control system via RF remote control and Wi-Fi interface with possibility of adjusting light intensity (0-100%) and colour temperature (2700-5500K). Power supply located inside the base. Mains power supply 90-264VAC. IP65 protection rating.

Maintenance

ALUMINIUM

To keep the product in good condition for a long time, we recommend cleaning it regularly; more often in very damp locations with a marine climate. It is recommended to clean the surfaces using a soft cloth with water or mild detergents. Prolonged and continuous exposure to intense UV radiation or very low temperatures can affect the initial characteristics of the coloured coating, which is made from polyester. We recommend cleaning and storing the products in sheltered places during prolonged periods of non-use and during the winter.


SYNTHETIC FABRICS
Avoid prolonged contact with greasy substances and/or dyes or colorants that could be absorbed by the covering material and cause permanent stains, as well as deteriorating the yarn structure. In the case of use near the sea or swimming pools, periodic washing is recommended. Frequent washing: follow the specific instructions given on the label for each material. Use water and non-abrasive, colorless, neutral PH liquid detergents. If necessary, allow the detergent to act for a few minutes. Rinse thoroughly with water at a temperature not higher than 30°C (86°F). If pressure cleaning devices are used, keep the tip of the nozzle at a distance of at least 60-70 cm from the surface of the product. If necessary, repeat the operation. Do not use abrasive sponges to remove stains and do not treat with bleach or chlorine.